Brew Group Cleaning - Saeco IDEA CAP002A Mode D'emploi Et D'entretien

MILK PROGRAMMING
HOT WATER MIXING
DISPENSER RINSING

BREW GROUP CLEANING

CLOCK
functions explanation
follows in the next page
MILK PROGRAMMING
The milk quantity programming can be enabled by selec-
ting:
- "ON", the button (Pr. 12.6) is programmed .
- "OFF", the button
dose has to be manually adjusted.
HOT WATER MIXING
While the different types of beverages are brewed, the
machine adds a certain amount of hot water, according
to the programming. By selecting:
- "ON", the mixing is performed
- "OFF", NO hot water will be added to the beverage.
NOTE - If the function is disabled the programmed figures
remain unchanged and ready to be used when the
function is re-activated.
ON
OFF
ON
OFF
ON MIN. XXX
OFF MIN. XXX
INSERT TABLET IN THE
GROUP
INSERT THE GROUP
CLOSE DOOR
CLEANING IN PROGRESS
REMOVE THE GROUP AND
WASH IN WATER
INSERT THE GROUP
CLOSE DOOR
CLEANING COMPLETED
PRESS STAR BUTTON
16:34 GI 8 NOV 2001
cannot be programmed, and the
DISPENSER RINSING
This function enables the brewing of a small hot water
quantity (abt 5 cc), in order to avoid any deposits in the
brew group. This cleaning starts automatically after the
programmed time (20÷240 minutes), from the last coffee
brewing. By selecting:
- "ON", the adjustment cursor blinks under the last right
figure, and the value can be increased or decreased
by 10 min;
every adjustment must always be confirmed.
- "OFF", no cleaning is performed.
NOTE - During the cleaning, the message "PROGRAMMED
CLEANING" will be displayed;
cleaning can also be activated manually by holding
the button for 3 seconds.
BREW GROUP CLEANING
This function enables the cleaning of the brew group (27)
using the provided tablets (for any information about tablets
ask to an Authorized Customer Service Center).
Procedures:
- The process begins from: "BREW GROUP CLEA-
NING".
- Press ; on display: "INSERT TABLET IN THE
GROUP".
- Remove the brew group; on display: "INSERT THE
GROUP";
- Put the tablet inside the brew group and refit the group;
on display: "CLOSE DOOR".
- Close the door; on display: "CLEANING IN PRO-
GRESS".
The cleaning cycle begins; at the end of the cycle the
message on display will be "REMOVE THE GROUP AND
WASH IN WATER".
- Remove the brew group; on display: "INSERT THE
GROUP".
- Wash the brew group in running water.
- Refit the brew group; on display: "CLOSE DOOR"
- Close the door; on display: "CLEANING COMPLETED.
PRESS STAR BUTTON" ;
Press to exit the menu definitely and make the machine
ready to be used.
NOTE - Cleaning can also be activated manually by hol-
ding the button
CLOCK
This function enables the clock and calendar set-up.
- By selecting "CLOCK", the cursor blinks on the hours,
that can thus be adjusted.
- After confirming the hour setting, the cursor moves on
the next figure to be adjusted (the minutes, then the day,
the month and finally the year).
English
for 8 seconds.
173