Maintenance And Storage - HeatStar MH35FA Instructions D'utilisation Et Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
OPERATING INSTRUCTIONS
PREPARING FOR OPERATION
1.­ Check­the­heater­for­possible­shipping­damage.­If­any­is­found,­
immediately­notify­the­factory.
2.­ Follow­all­of­the­"Precautions".­
3.­ Connect­the­POL­fitting­of­hose­and­regulator­assembly­to­the­
propane­cylinder­by­rotating­the­POL­nut­counterclockwise­into­
the­propane­cylinder's­valve­outlet­and­securely­tighten­with­a­
wrench.
4.­ Connect­the­hose­to­the­heater­by­rotating­the­hose­fitting­
clockwise.
5.­ Securely­tighten­all­gas­connections.
6.­ Open­the­cylinder's­gas­valve­and­check­all­gas­connections­with­
a­soap­and­water­solution.­DO­NOT­USE­A­FLAME.
7.­
Connect­power­cord­to­well-grounded­1 15V,­60­Hz,­1Ø­source­of­
power.
8.­ When­using­an­extension­cord,­make­certain­that­it­is­a­3-wire­
(grounded)­cord­of­proper­wire­size,­minimum­length­of­6­ft­
(1.83m).
START
1.­ THE HEATER POWER CORD MUST BE CONNECTED TO
A GROUNDED 115V, 60HZ, 1Ø POWER SOURCE BEFORE
HEATER IGNITION­and­always­allow­heater­fan­(blower)­to­run­
for­20­seconds­to­purge­fuel.
2.­ Open­propane­supply­valve­on­propane­tank­slowly.­­Note:­­If­not­
opened­slowly,­excess-flow­check­valve­on­propane­tank­will­stop­
gas­flow.­­If­this­happens,­close­propane­supply­valve­and­open­
again­slowly.­­Wait­15­seconds­before­­­­Step­3.
3.­ Push­and­hold­automatic­control­valve­button.­­Push­piezo­ignitor­
button­repeatedly­until­the­burner­lights.
4.­ After­the­burner­lights,­keep­the­gas­valve­button­depressed­for­
30­seconds­then­release­and­the­heater­will­continue­to­operate.
WARNING:­­Be­sure­motor­and­fan­are­running­before­pushing­
in­automatic­control­valve­button.­­Flames­could­flash­outside­
heater­or­internal­damage­to­heater­may­result­if­motor­and­fan­
are­not­running.
STOP
1.­ Securely­close­valve­on­the­propane­cylinder.
2.­ Continue­to­operate­heater­until­all­fuel­in­the­hose­has­burned.
3.­ Unplug­the­power­cord.
CAUTION:­­Always­shut­off­fuel­supply­before­disconnecting­
electrical­power.
RESTART AFTER SAFETY SHUTDOWN
1.­ Securely­close­valve­at­propane­cylinder.­­Unplug­power­cord.
2.­ Wait­5­minutes.­
3.­ Restart­following­"START"­procedure.
Forced Air Propane Construction Heater

MAINTENANCE AND STORAGE

1.­ The­heater­should­be­inspected­before­each­use,­and­at­least­
annually­by­a­qualified­person.
2.­ Before­each­use,­check­the­soft­"O"­ring­seat­at­the­bullnose­
of­the­POL­fitting.­If­the­"O"­ring­is­cut,­scuffed,­or­otherwise­
damaged,­replace­it­with­part­number­6681.
3.­ Turn­off­the­gas­at­the­LP-gas­supply­cylinder(s)­when­the­heater­
is­not­in­use.
4.­ When­the­heater­is­to­be­stored­indoors,­the­connection­
between­the­LP-gas­supply­cylinder(s)­and­the­heater­must­
be­disconnected­and­the­cylinder(s)­removed­from­the­heater­
and­stored­out­of­doors­and­in­accordance­with­Chapter­5­of­
the­standard­for­Storage­and­Handling­of­Liquefied­Petroleum­
Gases­ANSI/NFPA­58­and­CSA­B149.1,­Natural­Gas­and­Propane­
Installation­Code.
SERVICING
A­hazardous­condition­may­result­if­a­heater­is­used­that­has­been­
modified­or­is­not­functioning­properly.­When­the­heater­is­working­
properly:
The­flame­is­contained­within­the­heater.
*­­ The­flame­is­essentially­blue­with­perhaps­some­yellow­tipping.
There­is­no­strong­disagreeable­odor,­eye­burning­or­other­
physical­discomfort.
There­is­no­smoke­or­soot­internal­or­external­to­the­heater.
There­are­no­unplanned­or­unexplained­shut­downs­of­the­
heater.
The­parts­lists­and­exploded­view­show­the­heater­as­it­was­
constructed.­Do­not­use­a­heater­which­is­different­from­that­shown.­
In­this­regard,­use­only­the­hose,­regulator­and­cylinder­connection­
fitting­(called­a­POL­fitting)­supplied­with­the­heater.
IMPORTANT:­Match­the­color­stripe­on­the­hang­tag­attached­to­the­
hose­assembly­with­the­color­on­the­label­located­near­the­propane­
inlet­fitting­on­the­heater.­Do­not­use­alternates.­For­this­heater,­the­
regulator­must­be­set­as­shown­in­"specifications".­If­there­is­any­
uncertainty­about­the­regulator­setting,­have­it­checked.
A­heater­which­is­not­working­right­must­be­repaired,­but­only­by­a­
trained,­experienced­service­person.
In-warranty­products­will­be­repaired­with­no­charge­for­either­parts­
or­labor.­Please­include­a­brief­statement­indicating­date,­place­of­
purchase,­the­nature­of­the­problem­and­proof­of­purchase.
Out-of-warrranty­products­will­be­repaired­with­a­charge­for­parts­and­
labor.
5
Operating Instructions and Owner's Manual

Publicité

Table des Matières
loading

Table des Matières