Set Up; Battery Installation - Health O Meter 600KL Instructions D'utilisation

SET UP

Set Up
1. Remove the protective film from the display window on the display head.
2. Ensure the scale base is on a stable, level and flat surface and that the sides of the base are
clear of any obstacles.
3. Utilizing the leveling bubble located at the top of the scale platform, level the scale by adjusting
the leveling feet at each corner of the underside of the base.
Powering the Scale
1. For AC operation, the scale offers two areas to attach the AC adapter. The AC adapter can be
plugged into the base of the scale and into the power source. The AC adapter can also be
plugged into the "DC IN" plug on the back of the display module and then into the power source.
Note: The Auto Off function is only active when the scale is being used without the AC adapter.
2. For battery operation, see Battery Installation below.

Battery Installation

1. Place the scale on its side. The battery holder is located in the center of the bottom of the base.
2. Slide the battery cover in the direction of the "open" arrow.
3. Place the 6 C-cell batteries into the battery holder. Note the orientation that is shown and ensure
the batteries are placed in the proper direction. Do not use zinc-carbon batteries.
4. Replace the battery cover.
Note: When powering the scale via batteries, the AC adapter must be completely disconnected from
the scale.
Warning: If the scale will not be used for some time, remove all batteries to avoid a safety hazard.
Disposal of batteries should be done according to the national, regional or local regulations which
apply to you for disposal of batteries.
Battery compartment
(underside of scale platform)
9