Health O Meter 600KL Instructions D'utilisation page 8

600KL ASSEMBLY INSTRUCTIONS (continued)
4. Plug the load cell cable connector into the
load cell plug in the platform base. The
base of the scale has been designed to
provide wire management for the load cell
cable. Route the load cell cable as shown.
5. Set the base/pillar assembly upright. Obtain
the display head module. Plug the cable
labeled "SCALE" into the SCALE jack in the
display module. Plug the cable labeled
"COM" into the COM jack in the display
module.
6. Place the display module on top of the pillar
and align the tab on the front of the pillar
with the slot at the bottom of the display
module.
7. Remove the screw from the back of the
display module, place the module on top of
the pillar and use a Phillips screw driver to
replace and tighten the screw securing the
display head to the pillar.
8
Load cell cable port
Pillar tab