Health O Meter 600KL Instructions D'utilisation page 7

600KL ASSEMBLY INSTRUCTIONS (continued)
Prior to assembly, remove all brown cardboard in and around pillar, base, and display head.
1. Carefully remove the contents of the carton
and place each part on a flat, level, and dry
surface. Place the scale platform on its side
and align the pillar perpendicular to the
platform. The front of the display head on
the pillar should be facing forward and
above the scale platform.
2. Locate the load cell cable connector at the
bottom of the pillar. Feed the cable through
the opening at the base of the platform.
3. Insert the pillar into the pillar base on the
platform. Insert the 4 hex screws on the
underside of the platform and tighten using
the supplied 5mm Allen wrench.
Platform Base
Hex screws
7
Load Cell Cable Connector