Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000130-003.book Page 17 Thursday, December 15, 2016 1:40 PM
Working instructions.
Secure the power tool with the safety strap supplied at all times, especially for
WARNING
work carried out at elevated heights, when drilling horizontally or above the
head. If there is a power loss, or the power plug is pulled out, the magnetic holding power is
not maintained.
Fastening the safety strap (figure 9).
Fasten the machine securely around the
workpiece using the provided safety strap.
For switching the magnet ON
(figure 10).
Please make sure that the contact surface-
for the magnetic base is level, clean and
rust-free. Remove any varnish or primer.
When working, always use the magnetic foot;
pay attention that the magnetic holding
power is sufficient:
Press the Magnet button to start the machine.
– When the green Magnet button on the
control panel lights up permanently, the
magnetic holding power is sufficient and
the power tool can be operated with man-
ual or automatic feed.
– When the Magnet button on the control
panel flashes green, the magnetic holding
power possibly is insufficient and the
power tool must be operated manually
with reduced feed. In this case, the JCM
200 auto may not be operated in automatic
mode.
When working on non-metal materials, suit-
able clamping devices, such as the vacuum
plate or pipe-drilling fixture, which are avail-
able as accessories, must be used.
When working on steel materials with a
material thickness less than 12 mm, the work-
piece must be enforced with an additional
steel plate in order to ensure the magnetic
holding power.
The magnetic foot is monitored by means of
a power sensor. If the magnetic foot is defec-
tive, the drill motor will not start.
Clamping strap
=
JCM 200 QX, JCM 200 U, JCM 256 U
Switches the magnet On/Off
=
JCM 200 auto
en
17
Publicité
