Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000130-003.book Page 23 Thursday, December 15, 2016 1:40 PM
Feed without spoke handle
(JCM 200 auto) (figure 18).
Depending on the application, the feed can
also be actuated from the left-hand side. For
this, apply the drive socket.
To generate feed, turn the drive socket man-
ually while the drill motor is switched on.
Instructions for core drilling.
Do not stop the drill motor during the drilling
procedure.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
clockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Danger of burns! The surface
CAUTION
of the magnet can reach high
temperatures. Do not touch the magnet with
your bare hands.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
Fig.18
30 mm/
1 3/16 in
en
23
Publicité
