Fein GWP10 Mode D'emploi page 15

OBJ_BUCH-0000000204-001.book Page 15 Wednesday, April 15, 2015 10:12 AM
Mounting a tap with the jaw chuck
(figure 6).
Degrease the output spindle and the inside
cone of the jaw chuck before mounting.
Slide the jaw chuck onto the drive spindle.
Open the clamping ring and loosen the lock in
the jaw chuck using the Allen key.
Insert the tap.
Close the clamping ring and tighten the lock in
the jaw chuck using the Allen key.
Fig. 6
Drive spindle
Jaw chuck
1.
2.
3.
4.
Allen key
Tap
5.
en
15
6.