Fein GWP10 Mode D'emploi page 16

OBJ_BUCH-0000000204-001.book Page 16 Wednesday, April 15, 2015 10:12 AM
en
16
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 7).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Under no-load, the application tool rotates
counterclockwise; when applying pressure,
the rotation direction switches to clockwise,
and when pulling back, it switches to counter-
clockwise again.
For stationary use in a drill stand, remove the
switched off power tool from the drill stand
at operating temperature every 50 operating
hours and turn it by 180° to achieve uniform
lubrication.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Locking on:
Press the On/Off switch to the stop and press
in the Locking button.
Release the On/Off switch.
For switching off, briefly press the On/Off
switch until the Locking button disengages.
Release the On/Off switch.
Fig. 7
1.
2.
On/Off switch
1.
3.
2.