Trouble Shooting - Napoleon EFL100 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16

9.0 TROUBLE SHOOTING

EN
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A
QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
SYMPTOM
Dim or no fl ame
Appliance turns off
and will not turn on
Appliance will not
come on when
switch is fl ipped to
ON
Remote control
does not work
SYMPTOM
Flame belt is not
operational
W415-1140 / A / 07.04.13
!
PROBLEM
LED's are burnt out
Appliance has overheated
and safety device has
caused the thermal switch to
disconnect
House circuit breaker has
tripped
Appliance is not plugged
into an electrical outlet
Appliance has overheated
and safety device has
caused the thermal switch to
disconnect
Low batteries
PROBLEM
Belt has become
disengaged
Belt has broken
Motor does not work
WARNING
TEST SOLUTION
Inspect the LED's beneath the fl ame generation belt and re-
place them if necessary
Unplug the appliance, allow appliance to cool for 15 minutes,
then plug it back in
Reset house circuit breaker
Check plug and plug it in
Unplug the appliance, allow appliance to cool for 15 minutes,
then plug it back in
Replace batteries in remote control
TEST SOLUTION
Remove belt, check for obstructions, repair any damages and
reinstall the belt
Replace the broken belt
Replace the broken motor
42.28

Publicité

Chapitres

Table des Matières
loading

Table des Matières