Sensor Connection - Brüel & Kjaer Vibro AC-4704 Instructions D'emploi

EN
Installation
NOTE!
Before commissioning, make sure that the unused supply connectors (X105, X106) are
covered with blind plugs (see Figure 1) / label [6)]).
Figure 3) Connection Diagram

Sensor connection

NOTE!
The assembly may be carried out only in a voltage-free state (no measuring mode).
1. Place the shield of the sensor cable either on the shield terminal of the device (see Figure 1),
label [2)]) or on an external shield terminal.
NOTE!
Ensure correct polarity of the sensor lines. Polarity reversal can cause damage to the
sensor.
2. Connect the SIG and COM wires of the sensor cable to the SIG and COM of the socket x10x.
█
Page 10 of 18 © Brüel & Kjaer Vibro ● 10/2017 ● C106022001 / V05 ●
Technical alterations reserved!