Replacing Injectors - Franke MARIS FREE FHMF 604 3G DC C Manuel D'installation

EN
that ensures complete disconnection in
category III overvoltage conditions.
Ensure the following:
X
– The characteristics of your
household electrical power supply
(voltage, maximum output and
current) are compatible with those of
your FRANKE hob.
– The plug and socket are suitable for
a 16 A current.
– The plug and the socket can be
easily reached and are positioned so
that no live part is accessible when
inserting or removing the plug.
– The plug can be inserted without
difficulty and is accessible with the
appliance installed.
– The appliance does not rest against
the plug when installed in the
worktop.
– A 3 x 0.75 mm
for completely gas hobs is used
when replacing the power cable.
– The terminals of two appliances are
not connected to the same plug.
– The polarities of the free
terminals (Blue = Neutral = (1) /
Yellow and Green = Earth = (2) /
Brown = Live = (3)) are respected.
REPAIR
If the power cable is damaged, it must
be replaced by the manufacturer or the
service or else by a person with similar
qualifications, in order to avoid any risks.
FHMF 604 3G DC C / FHMF 604 4G C / FHMF 755 4G DC C
H05RR-F type cable
2

Replacing injectors

Important: All the appliances are
factory-set for natural gas (G20).
If a different type of gas is to be used,
change the injectors as follows:
Remove the grids, burner caps and
X
flame-spreaders;
Unscrew the injectors and replace them
X
with those provided and suitable for the
gas supply, making sure the marking
matches that given in the table;
Refit the flame-spreaders, burner caps
X
and grids;
These burners do not require air
adjustment.
Accessing the hob
To access the tray containing the
functional parts, proceed as follows:
Remove the grids, burner caps and
X
flame-spreaders;
Remove the knobs, sliding them off
X
their pins;
Remove the screws that fix the
X
burners to the hob;
Lift the hob.
X
Important : When converting the
appliance to a different type of gas, place
the corresponding sticker (supplied as
an accessory) in the special space on
thedataplate. For operation with LPG (G30
or G31), the minimum flame adjustment
screw must be fully screwed down. These
appliances are supplied in cat. II 2H3+.
Warning!
Before attempting any repairs on the
Z
appliance, disconnect the power supply.
– 8 –