General Regulations For Use - Orved A Mode D'emploi Et D'entretien

VACUUM CHAMBER
PACKAGING MACHINES
5.3

GENERAL REGULATIONS FOR USE

ELECTRIC HAZARD! First check the voltage indicated on the nameplate to make sure it corresponds to that of your mains
supply. ELECTRICAL SAFETY OF THIS MACHINE IS ONLY ENSURED BY CONNECTING IT CORRECTLY TO AN EFFECTIVE
EARTHING SYSTEM, AS ENVISAGED BY SAFETY STANDARDS. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
DAMAGE CAUSED BY THE ABSENCE OF EARTHING OF THE ELECTRICAL SYSTEM.
ELECTRIC HAZARD! Insert and disconnect the plug in the power socket always with the
machine switched off; pull out the plug, not the cable.
Only qualified personnel are allowed to accede to powered parts.
WARNING! Position the machine on a solid, safe level horizontal work table.
In carriage-mounted models, brake the two front wheels by lowering the front wheel pedals.
WARNING! The appliance must be positioned in such a manner as to allow access from all sides.
This will also ensure necessary ventilation of the machine.
In any case, there must be a clearance of at least 10 cm around the machine.
WARNING! If the machine includes the gas option, fix the cylinders to the wall.
After using the machine, and after switching it off, also close the cylinder valve and pressure reducer valve.
DANGER! In appliances provided with the gas option, IT IS FORBIDDEN TO USE GAS MIXTURES CONTAINING OXYGEN OR
OTHER EXPLOSIVE GASES OR FUELS. The gas mixture must be factory-set at the manufacturer's or adjusted by authorized
personnel in the place where the machine is used.
Gas cylinder supply and installation must be handled by the supplier's qualified personnel.
ATTENTION! If the vacuum and sealing time parameters of the work cycle are set at the maximum value, (at approx. 50
seconds of vacuum and 6 seconds of sealing) , there must be an interval of at least 30 seconds between cycles.
ATTENTION! Stop the machine immediately if there is gas leakage caused by defective or rusty unions or damaged pipes.
Contact your nearest Service Centre for replacement of damaged parts.
WARNING! To avoid increase in oil density which could affect regular working of the pump, make sure that the environmental
temperature never falls below 10°C.
WARNING! The pump oil must be checked every time the machine is used through the level glass provided on the side of the
machine's rear panel (Fig. 4). The oil level must be between the MINIMUM and MAXIMUM level.
The oil must be golden coloured and clear.
REV. 00 - Cod.: 1500159
Fig. 4
47
INSTALLATION
NO
Operation and maintenance manual / Ed. 02 - 2006
GB
OK
GB