Stanley BA 550/11/200 Manuel Utilisateur page 29

FAULT
After an attempt to start the
compressor, it stops due to tripping
of the thermal cutout caused by
forcing of the motor.
During operation, the compressor
stops for no apparent reason.
When operating, the compressor
vibrates and the motor emits an
irregular buzzing sound. If it stops,
it does not restart although the
sound of the motor is present.
Irregular presence of oil in the
network.
Leaking of condensate from the
vent cock.
Any other type of operation must be carried out by authorized Service Centers, requesting original parts.
Tampering with the machine may impair its safety and in any case make the warranty null and void.
CAUSE
Start-up with head of the
compressor charged.
Low temperature.
Voltage too low.
Incorrect or insufficient lubrication.
Inefficient electrovalve.
Tripping of the thermal cutout of
the motor.
Electric fault.
One of the phases of the 3-phase
power supply is missing due
probably to blowing of a fuse.
Too much oil inside the unit.
Wear on segments.
Presence of dirt/grit inside the
cock.
29
REMEDY
Release the compressor head by
using the pressure switch push
button.
Improve ambient conditions.
Check that the mains voltage
matches that of the dataplate.
Eliminate any extensions.
Check level, top up and if
necessary change the oil.
Call the Service Center.
Check level oil.
Versions with delta-star starter:
operate on the button of the
thermal cutout located inside the
box of the electric panel (fig. 2d)
and restart (fig. 2a-2b-2c).
If the fault persists, call the Service
Center.
Other versions:
Operate on the button of the
pressure switch returning this to
the OFF position and then to ON
again.
If the fault persists, call the Service
Center.
Call the Service Center.
Check the fuses inside the electric
panel or the electric box and if
necessary replace those that have
been damaged (fig. 25).
Check oil level.
Call the Service Center.
Clean the cock.
G
B