Uc130 Cylinder Description; Technical Features - Ultraflex UC 130 Manuel D'installation Et D'entretien

ULTRAFLEX

1.4 UC130 cylinder description

UC130 is a hydraulic outboard front mount cylinder which has been designed and manufactured to be used
as a component in the hydraulic steering systems, as described in the previous paragraph.
The cylinder is installed to the tilt tube rod of the available engines on the market as shown in the attached
document "Application guide". It is possible to meet all the different cylinder applications due to the three
different link arms and a proper spacer kit. For the dual engine application, the single cylinder must be
mounted with a tie bar (see par. 1.3) or two cylinders (standard + port) connected by a tie bar can be used.
In the standard version the link arm is mounted on the starboard side, while in the port version it is mounted
on the port side (see picture in par. 1.5). The following picture shows the main cylinder components:
1
Cylinder body
2
Bleeders
3
Bull horns
4
Tilt tube rod
5
Spacers
6
Adjustment collar
7a
Straight link arm
7b
Shaped link arm
represented in both versions, starboard
and port)

1.5 Technical features

SPECIFICATIONS
Volume
Output force* 7,39kN @105bar (1500PSI)
Inside diameter
Stroke
Oil
STANDARD VERSION (STARBOARD)
CAUTION
*The cylinder output force is a theoretical force with a system pressure of 105 bar. This force does not
correspond to the one normally used by the system but it represents the limiting conditions of use.
6
5
3
(UC130 -
2
UC 130
130 cm³
Ø36mm
185 mm
OL150 Ultraflex
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
7b
7a
1
PORT VERSION
4
3
2
545 mm
page 9
- of 83