Removing The Storage Drawer; Completing The Move; Fitting The Flue Grille; Levelling - Falcon 900S Mode D'emploi

Removing the Storage Drawer

Pull the drawer out to its furthest point (Fig.7-5).
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners (Fig.7-6).
For safety's sake push the drawer runners back out of the way
and put the drawer somewhere safe until the installation is
complete.
When you have removed the oven door and removed the
storage drawer continue as follows:
First fit the levelling tool on the hexagonal adjusting nut
(Fig.7-7).
Make 10 complete (360°) turns clockwise (Fig.7-7). (This
means turning and removing the levelling tool 20 times.)
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.

Completing the Move

Unfold the rear edge of the pack base tray.
Grip under the fascia panel and lift the front of the cooker
slightly (Fig.7-8).
Carefully push the cooker backwards off the pack base.
Remove the pack base tray. Position the cooker close to its
final position, leaving just enough space to get behind it.
DO NOT use the door handles or control knobs to

manoeuvre the cooker.
Push the range close to its final position, leaving just enough
space to get behind it (Fig.7-9).

Fitting the Flue Grille

The flue grille is packed separately (Fig.7-10).
The larger of the holes along the sides are for screwdriver
access and should face to the rear. Use the screws and nuts
supplied to fix the grill in place (Fig.7-11).
Clip the flexible extensions of the oven flues to the flue grille
using the clips provided inside the flue grille.

Levelling

It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker, use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
ArtNo.342-0005 - 90SC Induction - Drawer position
ArtNo.342-0002 - Elan - drawer position
x10
Fig.7-8
ArtNo.010-0004 Moving the cooker
ArtNo.280-0029 - Flue Grill
ArtNo.280-0030 - Fixing Flue Grill
19
ArtNo.010-0010 Lowering the rear rollers (90)
ArtNo.010-0009 Pushing the cooker
English
Fig.7-5
Fig.7-6
Fig.7-7
Fig.7-9
Fig.7-10
Fig.7-11