Connecting Sensors Or Flow Meters - Hunter Hydrawise PRO-HC Guide De Démarrage Rapide

CONNECTING SENSORS OR FLOW METERS

Pro-HC Controller supports most open/closed contact type of sensors, such as Hunter
rain and soil moisture sensors.
1. Connect one sensor wire to COMMON on the controller.
2. Connect the Normally Closed or Normally Open wire from the sensor to SEN-1 or
SEN-2 on the controller and configure in the Hydrawise app.
Wiring for standard Hydrawise 0.75" (20 mm) or
1" (25 mm) flow meters is as follows:
Flow Meter Wire
Blue
White
Red
Wiring for open/closed contact sensors is as follows:
Sensor Wire
Normally Open /
Normally Closed wire
Second (common) wire
7
Label on Controller
SEN-1, SEN-2
SEN COM
Not connected
Label on Controller
SEN-1, SEN-2
SEN COM
For full details, refer to the instructions
provided with your sensor, or flow meter.
Once you've wired your sensor, you must
configure it in your Hydrawise account.
See Configuring Sensors at
hydrawise.com/support
instructions on setting up sensors.
(OPTIONAL)
for full