Connecting Station Wires - Hunter Hydrawise PRO-HC Guide De Démarrage Rapide

CONNECTING STATION WIRES

1. Route valve wires between control valve
location and controller.
2. At valves, attach a common wire to
either solenoid wire of all valves. This is
most commonly a white-colored wire.
Attach a separate control wire to the
remaining wire of each valve. All wire
splice connections should be done using
waterproof connectors.
3. Route valve wires through the conduit
and attach conduit to one of the
openings on the bottom of the cabinet.
4. Strip ½" (13 mm) of insulation from ends
of all wires. Secure the valve common
wire to "COM" (Common) terminal.
Attach all individual valve control wires
to the appropriate station terminals.
Note: All wire connections should be done using waterproof connectors. Connect
each of the other individual wires to a different colored wire. Record zones against
wire color for later reference. Connect the common wire from the multicore cable
(usually white) to the terminals on the controller marked COM.
6