Hunter Hydrawise PRO-HC Guide De Démarrage Rapide page 6

Outdoor cabinet
The outdoor model is water and weather resistant. Connecting the outdoor Pro-HC to the
primary power should be done by a licensed electrician following all local codes.
1. Route AC power cable and conduit
through the ½" (13 mm) conduit opening
on the left side of the bottom of the
cabinet.
2. Connect the wires to the transformer
wires located inside the junction box.
International units are supplied with a
built-in terminal strip. Always use a UL
listed conduit ½" (13 mm) male adapter
when installing the AC wiring.
HOT
(Black)
NEUTRAL
(White)
GROUND
(Green)
Note: To be performed by a licensed electrician only. Always use UL listed ½" (13 mm)
conduit with male adapter when installing AC wiring. Pro-HC controllers are
intended to be supplied AC power with an over-current protected device. Improper
installation could result in shock or fire hazard. This device is not intended for use by
young children. Never let children play with this device.
5
3. Insert the adapter into the ½" (13 mm)
hole at the bottom of the controller.
Attach a nut to the adapter inside the
enclosure.
4. A battery is not required for this controller.
Watering will not occur without AC power.
Since this controller has non-volatile
memory, the program, clock, and calendar
will be retained during a power outage.