Pentair MICROBRITE 620424-EU Manuel D'utilisation page 7

WET CONDUIT INSTALLATION
Note: MicroBrite lights are shipped from the factory with the white threaded adaptor ring pre-installed onto the
body of the light. The male threads on the white threaded adaptor ring allow the light to be threaded into the female
threads of most 1.5" pool wall return fittings.
To install the MicroBrite light wall fitting into a concrete/vinyl pool:
1. To install a MicroBrite light, route the MicroBrite
light power cord light cable through the 1.5" wall
fitting to the location of the junction box.
2. Wrap plumber' s thread sealant tape around the
male threads on the white threaded adaptor ring
on the light.
Wrap threaded sealant tape
around the adaptor
4. With the MicroBrite light in your hands, roll the
body of the light several turns counter-clockwise,
so that the cord of the MicroBrite light receives
several "pre-twists" in a counter-clockwise direc-
tion. Read Step 5 before continuing with Step 6.
By hand, turn light body
counter-clockwise to twist cord
LIGHT INSTALLATION
3. Pull the MicroBrite power cord through the conduit
5. Dry/Sealed Conduit Installation (use provided kit),
Cord should be twisted counter-clockwise
MicroBrite color led light for pool and spa Installation and User' s Guide
so there is approximately 7 to 15 cm of visible cord
between the body of the MicroBrite light and the
wall fitting.
1.5" Standard
wall fitting
see page 9: If code requires an O-Ring to be in-
stalled on the light for a dry conduit installation,
install the O-Ring as described on page 9, then
continue with Step 6 below.
7