Pentair MICROBRITE 620424-EU Manuel D'utilisation page 5

MICROBRITE® COLOR LED LIGHT OVERVIEW
This manual describes how to install, replace and operate the 12 VAC MicroBrite Color for pool and spa. The
MicroBrite Color light provides brilliant vivid multi-colors with spectacular effects for your pool. Choose one of the
seven pre-programmed color light shows or select one of the five fixed colors to create virtually endless range of
dramatic underwater lighting effects for a spectacular effect in your pool and spa.
GLOBAL WIRING INSTALLATION RULES
MICROBRITE® COLOR LED LIGHT WIRING INSTALLATION
To connect the MicroBrite light to a junction box:
1. Route the MicroBrite light power cord light
cable through the wall fitting to the location of the
junction box.
2. At the junction box, leave at least 15 cm of cord to fa-
cilitate the light installation. Cut off any extra cord.
WARNING: Electrical wiring to the lighting must
be in accordance with the latest edition of the
Electrician Wiring Rules (see p4).
3. Connect the two (2) conductors to the corre-
sponding circuit wires in the junction box. Secure
the junction box cover.
GLOBAL PRESENTATION
4. Before operating the MicroBrite light, fill the pool
5. Final check for proper MicroBrite light operation:
MicroBrite color led light for pool and spa Installation and User' s Guide
with water until the light is completely submerged.
Note: The MicroBrite color light should not be
powered for more than 30 seconds if is not sub-
merged in water.
Switch on the main switch or circuit breaker to
the 12 VAC transformer and the switch that oper-
ates the MicroBrite light itself. The light should
illuminate when the 12 VAC power is applied. If not
recheck the installation steps.
5