Pentair MICROBRITE 620424-EU Manuel D'utilisation page 13

OPERATING MICROBRITE® COLOR LED LIGHT USING
A CONTROLBRITE®
Refer to ControlBrite' s user manual for wiring.
Selecting color and show modes using a ControlBrite®
The MicroBrite color light can be controlled with the
ControlBrite (p/n CTRB-1010, sold separately). The
ControlBrite provides complete control of your Micro-
Brite color lights. Just press remote control buttons to
color light shows or fixed colors. The ControlBrite can be
connected to individual or multiple 12 VAC transformers
(300W maximum) to control MicroBrite color lights.
• Use the ON/OFF key on the remote control or main
unit to switch the lights on or off.
• Use the >> or << key (remote or main unit) to
change to the next/previous color scheme. It will
take a few seconds for the new scheme to become
active.
On the remote control it is possible to switch from xed
colors to sequences using the II> key.
ELECTRICAL CONNECTION
Hold and Recall:
ControlBrite allows you to store a specific color to be
used as one of the fixed colors. To memorize this color,
press the II> key on the remote control twice with a 1
sec interval. This function only works with one of the
sequences running. The saved color can be activated
using the 'recall' fixed color. The display will show 'U'.
MicroBrite color led light for pool and spa Installation and User' s Guide
ON / OFF
Mode selector:
• 1 push =
fixed color / sequence
• 2 pushes = save actual
color as user defined color
(sequence mode only)
Next
color scheme
Previous
color scheme
13