Pentair MICROBRITE 620424-EU Manuel D'utilisation page 11

OPERATING MICROBRITE® COLOR LED LIGHT USING A WALL SWITCH
MicroBrite color lights can be controlled using a standard
wall-mount light switch (or by the IntelliBrite® Controller,
see page 12). Multiple MicroBrite color lights can be con-
nected via a junction box and a 12 VAC transformer to a
single switch so that all lights can be switched on and off
together. MicroBrite color lights are controlled by cycling
AC power to the 12 VAC transformer from a standard wall
Interrupteur
Transformer compliant with NF EN 61558-2-6
SELECTING A MICROBRITE COLOR LIGHT SHOW MODE OR FIXED COLOR USING
A WALL SWITCH
MicroBrite color lights are compatible with IntelliBrite® Color Light shows and can be synchronized with IntelliBrite
color lights. First switch power on to the light. A white light will momentarily illuminate, followed by the previously
selected color. To select a color show mode (1-7) or fixed color (8-12), turn the wall switch off/on a specic number
of times.
Each number (1-12) shown below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color. For details about saving color effects while in "show" modes, see "Hold" and "Recall" feature
on page 10.
1. SAm Mode: Cycles through white, magenta, blue
and green colors (emulates the SAm color changing
light).
2. Party Mode: Rapid color changing building energy
and excitement.
3. Romance Mode: Slow color transitions creating a
mesmerizing and calming effect.
4. Caribbean Mode: Transitions between a variety of
blues and greens.
5. American Mode: Red, white and blue transition.
6. California Sunset Mode: Dramatic transitions of or-
ange, red and magenta tones.
Example: To select California Sunset Mode; turn the switch on, then off and on six (6) times. During the off/on
switching process, no illumination will occur, then a white light will momentarily illuminate.
During the off/on switching process, before the selected color is displayed, no illumination will
occur. This operating mode is normal during the switching process. During this period the pool and
spa will be dark and precautions should be taken to avoid unforeseen accidents. Failure to observe this warning
may result in serious injury or death to pool and spa users.
ELECTRICAL CONNECTION
PHASE(L)
NEUTRAL (N)
MicroBrite color led light for pool and spa Installation and User' s Guide
switch. By turning the switch on and off a specific
number of times, the light activates one of the seven
light show modes, fixed colors, or enables the "Hold" and
"Recall" feature.
Note: Up to six (6) MicroBrite 12 V AC lights can be con-
nected to a 100W transformer
2A
Wire connectors
2A
Junction box
7. Royal Mode: Richer, deeper color tones.
8. Blue: Fixed color.
9. Green: Fixed color.
10. Red: Fixed color.
11. White: Fixed color.
12. Magenta: Fixed color
13. Hold: Save the current color effect during a color
light show.
14. Recall: Activate the last saved color effect.
11