Raincover; Folding The Stroller - Chicco urban Mode D'emploi

RAINCOVER

The stroller is equipped with a raincover.
32. To secure the raincover, completely open the stroller's canopy
and wrap the raincover around the external tube of the backrest.
To complete the assembly, also wrap the opposite side of the
raincover around the tube in the foot area (fig. 32). After use, hang
the raincover to dry (if it is wet) before folding and storing it away
out of the reach of children.
WARNING: Pay particular attention when using the raincover.
WARNING: Use only the supplied raincover.
WARNING: Use the raincover only after purchasing the ''Colour
Pack'' and assembling the canopy. The rain raincover cannot
be used on the stroller without the canopy; it may represent a
suffocation hazard for the child. When the raincover is assembled
on the stroller, never leave the stroller exposed to the sun with
your child inside of it, to avoid over-heating hazards.
COLOUR PACK (to purchase separately)
List of components:
· CANOPY
· SEAT INSERT
· COMFORT KIT
· LEGCOVER / PRAM APRON
CANOPY
A canopy can be installed on the stroller.
The seat features two joints positioned on the sides of the backrest
that allow the securing of the canopy.
33. To secure the canopy, introduce the fastening system into the
joints as shown in (fig. 33).
34. Then, secure the fabric part to the canopy using the zip located
on the seat frame, around the backrest. (Fig. 34).
WARNING: The canopy must be anchored to both sides of the
stroller. Make sure it is secured properly.
35. To remove the canopy, open the zip of the canopy's fabric
part completely and press the buttons located inside the canopy's
joints then pull the canopy upward (fig. 35).
36. To adjust the canopy, pull and/or push it centrally (fig. 36).
SEAT INSERT
To use it during the early months of your child's life, use the
seat insert sold with the ''Colour Pack''. The seat insert must be
assembled in stroller configuration.
To properly position the safety belts on the stroller's backrest,
refer to paragraph ''USE OF THE SAFETY BELTS IN STROLLER
CONFIGURATION''.
37. At this point, thread the belts in the relative slots located on
the insert's backrest. Repeat the same operation for the waist belt
and the crotch strap as shown in fig. 37.
COMFORT KIT
38. The ''Colour Pack'' includes a comfort kit containing 2 shoulder
strap pads (A), a crotch strap cover pad (B) (fig. 38).
39. For assembly, thread the shoulder straps in the slots as shown
in (fig. 39), making sure the vertical stitching is facing outward.
The shoulder straps can be adjusted according to your child's size.
40. Introduce the crotch strap in the relative slot as shown in fig.
40.
LEGCOVER / PRAM APRON
41. This component (Fig. 41A) can be used in two different ways: as
legcover in stroller configuration (fig. 41B) and as an apron in pram
configuration (fig. 41C).
42. To secure it, wrap it around the structure, threading it under
the bar and then fasten it to the frame using the external and
internal press stud buttons (fig. 42A-42B).

FOLDING THE STROLLER

To fold the stroller and make it more compact, adjust the handle
in the lowest position, unlock the front wheels so they swivel, and
remove the seat.
43. To remove the seat, press the grey buttons located near the
seat's articulated joints (Fig. 43).
44. To close the stroller, slide button 1 and then press buttons 2
and 3(Fig. 44).
25