Cleaning; Troubleshooting - AKG SR40 FLEXX Mode D'emploi

BDA SR 40 FLEXX_2008_Hex:Layout 1
• Use a soft cloth moistened with water to clean the receiver surfaces.
Problem
No sound.
Noise, crackling, unwanted signals.
Distortion.
SR 40 FLEXX
01/21/2008 10:32

4 Cleaning

Possible Cause
1. AC adapter is not connected to re-
ceiver and/or power outlet.
2. Receiver is OFF.
3. Receiver is not connected to mixer
or amplifier.
4. VOLUME control on receiver is at
zero.
5. Microphone or instrument is not
connected to bodypack transmitter.
6. Transmitter is tuned to different fre-
quency than receiver.
7. Transmitter on/off switch is at
"OFF" or "MUTE".
8. Transmitter battery(ies) is(are) not
inserted properly.
9. Transmitter battery(ies) dead.
10. Transmitter is too far away from re-
ceiver or squelch threshold setting
is too high.
11. Obstructions between transmitter
and receiver.
12. Receiver is invisible from transmit-
ter location.
13. Receiver is too close to metal ob-
jects.
1. Antenna location.
2. Interference from other wireless
systems, TV, radio, CB radios, or
defective electrical appliances or
installations.
1. GAIN control is set too high or too
low.
Seite 19 (Schwarz/Black Auszug)

5 Troubleshooting

Remedy
1. Connect AC adapter to receiver
and/or power outlet.
2. Push ON/OFF switch to switch re-
ceiver ON.
3. Connect receiver output to mixer or
amplifier input.
4. Turn up VOLUME control.
5. Connect microphone or instrument
to audio input on bodypack.
6. Tune transmitter and receiver to
same frequency / use transmitter
with compatible frequency.
7. Set transmitter on/off switch to
"ON".
8. Insert battery(ies) conforming to
"+" and "-" marks.
9. Replace battery(ies).
10. Move closer to receiver or reduce
squelch threshold setting.
11. Remove obstructions.
12. Avoid spots where you cannot see
receiver.
13. Move receiver away from or re-
move interfering objects.
1. Relocate receiver.
2. Switch off interference sources or
defective appliances; switch trans-
mitter and receiver to different fre-
quency / use transmitter and
receiver operating in a different fre-
quency band; have electrical instal-
lation checked.
1. Handheld transmitter: Set GAIN to
alternative position.
Bodypack transmitter: Turn GAIN
control down or up just enough to
stop the distortion.
19