Connecting The Receiver To Power; Setting Frequencies - AKG SR40 FLEXX Mode D'emploi

BDA SR 40 FLEXX_2008_Hex:Layout 1
1
2
3
5
6
1. Check that the AC mains voltage stated on the included power supply is identi-
cal to the AC mains voltage available where you will use your system. Using the
power supply with a different AC voltage may cause damage to the unit.
2. Point the antennas (1) upward.
3. Plug the feeder cable on the included power supply into the DC ONLY socket (13) on the
receiver.
4. Bend part of the feeder cable into a small bight, pass the bight through the strain relief
(12) from above, and slip the bight over the hook on the strain relief (12). Tighten the
cable.
5. Plug the AC adapter into a convenient power outlet.
6. To switch power to the receiver on, press ON/OFF (2). To switch power to the receiver
off, press ON/OFF (2) again.
Your receiver can only receive the transmitter signal if
a) the transmitter and receiver operate within the same frequency band; and
b) the transmitter and receiver are set to the same frequency within this frequency band.
SR 40 FLEXX
01/21/2008
12
4
13
10:32 Seite 17
3 Setting up
3.4 Connecting
the Receiver to Power
12
Fig. 5: Connecting to power.
L
Refer to fig. 5.

3.5 Setting Frequencies

(Schwarz/Black Auszug)
17