Cleaning; Troubleshooting - AKG WIRELESS SR 40 diversity Mode D'emploi

8. The RF/OK LED on the receiver going out means no signal is recei-
ved or the squelch is active.
Remedies: Switch power to the transmitter ON and/or move closer
to the receiver to a point where the RF/OK LED will come back on.
9. The AF/PEAK LED on the receiver flashing frequently or glowing
constantly means the transmitter signal is too strong.
Turn the GAIN control on the transmitter CCW to the point that the
AF/PEAK LED will only flash occasionally.
Use a soft cloth moistened with water to clean the receiver surfaces.
Problem
No sound.
4 Operating Notes

6 Troubleshooting

Possible Cause
1. AC adapter is not connect-
ed to receiver and/or power
outlet.
2. Receiver is OFF.
3. Receiver is not connected
to mixer or amplifier.
4. VOLUME control on receiv-
er is at zero.
5. Microphone or instrument
is not connected to body-
pack transmitter.
6. Transmitter and receiver
color codes are not
identical.
7. Transmitter on/off switch is
at "OFF" or "MUTE".
8. Transmitter batteries are
not inserted properly.
9. Transmitter batteries dead.
10.Transmitter is too far away
from receiver.
11.Obstructions between
transmitter and receiver.
12.Receiver is invisible from
transmitter location.
13.Receiver is too close to
metal objects.

5 Cleaning

Remedy
1. Connect AC adapter to
receiver and/or power out-
let.
2. Push POWER switch to
switch receiver ON.
3. Connect receiver output to
mixer or amplifier input.
4. Turn up VOLUME control.
5. Connect microphone or
instrument to audio input
on bodypack.
6. Use receiver and trans-
mitter with identical color
codes.
7. Set transmitter on/off
switch to "ON".
8. Insert batteries conforming
to "+" and "-" marks.
9. Replace batteries.
10.Move closer to receiver.
11.Remove obstructions from
between transmitter and
receiver.
12.Avoid spots where you
cannot see receiver.
13.Move receiver away from or
remove interfering objects.
17