Assembly And Adjustments - Skil 3376 Consignes D'utilisation/De Sécurité

SM 2610028631 01-13_SM 2610028631 01-13.qxp 1/9/13 2:37 PM Page 9
To reduce the risk of injury, never
WARNING
connect plug to power source outlet
until all assembly steps are completed.
Installing sanding disc and guard
1. Remove the backing from the sanding disc (1).
Align perimeter of disc with sanding plate (2) and
press disc firmly into position all the way around, as
shown in figure 2.
2. Locate the disc guard (3) and three pan head
screws (4).
3. Position disc guard against lower 1/3 of disc
aligning holes.
4. Using a Phillips screwdriver, fasten the pan head
screws securely, applying light pressure to thread
the holes, as shown in figure 3.
Note: Use 6 inch Abrasive discs only.
Installing table assembly
1. Slide the table (5) into the table mounting braket (6)
of the base, as shown in figure 4.
2. Use hex key 4 mm (7) to secure the table in place.
To avoid trapping the work or
WARNING
fingers between the table and
sanding surface, the table edge should be a
maximum of 1/16" (1.6mm) from sanding surface.

Assembly and adjustments

(Fig. 2 & 3)
(Fig. 4)
FIG. 2
2
1
FIG. 3
4
3
FIG. 4
6
7
9.
BELT DIRECT
ION
BELT DIREC
TION
5