Assembly - Skil 7510 Guide D'utilisation

ASSEMBLY

Removing and installing sanding belts
WARNING
Keep your fingers and clothing away from the belt. They could get cut or wedged between
the pulley, belt and motor housing.
To Remove Belt
1. Place sander on it's side and move lever in
direction of arrow to retract front pulley and
release belt tension (Fig. 2).
2. With the sander on it's side and the open side
facing you, you can easily remove the belt.
To install belt
1. While the sander is still on it's side with the front pulley retracted and locked, insert the new
belt around both pulleys and over the metal plate. If belt has directional marks, be sure the
arrow on the inside of belt is pointing in the direction of rotation as indicated on housing.
2. Then push lever back to its original position to return tension to the belt.
Microfilter dust canister
the integral dust extraction system collects sanding dust in canister supplied with your sander.
For maximum efficiency, the dust canister should be emptied frequently during operation.
WARNING
careful of dust disposal, materials in fine particle form may be explosive. Do not throw sanding
dust on an open fire. Combustion from mixture of varnishes, lacquers, polyurethane, oil or
water with dust particles can occur if there is a static discharge, spark introduced in the box, or
excessive heat.
To prevent personal injury, always disconnect the plug from the power
source before removing or installing the belt.
Your tool is equipped with a dust canister, empty it frequently, after
completion of sanding and before storing the sander . Be extremely
Fig. 2
Belt Tension Release
Lever
Rear Pulley
Direction Of
Travel
Front Pulley
Metal Plate
11