Skil 3376 Consignes D'utilisation/De Sécurité page 15

SM 2610028631 01-13_SM 2610028631 01-13.qxp 1/9/13 2:37 PM Page 15
Sanding curved edges
1. Always sand inside curves on idler drum as shown
in figure 16.
Never attempt to sand the ends of a
WARNING
workpiece on the idler drum.
Applying the end of the workpiece to the idler drum
could cause the work piece to fly up and result in an
injury.
2. Always sand outside curves on the left hand side of
the sanding disc, as shown in figure 17.
Applying the workpiece to the right
WARNING
side of the disc could cause
workpiece to fly up (kickback) and result in injury.
Sanding small end surfaces
on the sanding disc (Fig. 18)
1. Use of the miter gauge is recommended for this
operation.
2. Rest the workpiece against the edge of the miter
gauge.
3. Always move the work across the left hand side of
the sanding disc, as shown in figure 18.
4. The table may be tilted for bevelled work.
Operation
(Fig. 16 & 17)
FIG. 16
FIG. 17
FIG. 18
15.
BELT DIRECT
ION