Skil 3376 Consignes D'utilisation/De Sécurité page 11

SM 2610028631 01-13_SM 2610028631 01-13.qxp 1/9/13 2:37 PM Page 11
Auxiliary mounting for vertical sanding
1. Remove table assembly by loosening hex set
screw (1) using 4mm hex key.
2. Loosen the belt bed locking screw (2) and raise the
belt sander bed (3) to the vertical position, figure 8.
3. Retighten the locking screw (2).
4. Slide the table (4) into the table mounting braket (5)
of the belt bed, as shown in figure 9.
5. Use 4 mm hex key (6) to secure the table in place.
To avoid trapping the work or
WARNING
fingers between the table and
sanding surface, the table edge should be a
maximum of 1/16" (1.6mm) from sanding surface.
Assembly and adjustments
(Fig. 8 & 9)
6
5
11.
FIG. 8
3
2
1
FIG. 9
4