Gluing Instructions; Indoor Installation - Megasat Caravanman Kompakt Mode D'emploi

2. Installation
5. Roughen the surface with sandpaper (120 grit) slightly and clean the surface again
with cleaner (NOTE: Do not touch areas) and allow the cleaner to dry for about 10
minutes.

2.2 Gluing instructions

1. Prepare the glue for mounting.
2. Now take the glue on the underside of the antenna base in
serpentine lines, so that the glue can harden well to the in-
side.
3. Now place immediately (within 5 minutes after adhesive application), the antenna on
the marked fields. Press the feet slightly and evenly and fix the antenna so that it stays
in place, eg by an adhesive tape. After pressing, at least 2 mm glue must be between
antenna and surface. The adhesive is cured max. in 48 hours at +18° C and a relative
humidity of 50%. Should prevail low humidity during the assembly time, spray after
bonding in the vicinity of the antenna some water in the air some time.
4. Remove any spilled adhesive immediately with a putty knife or similar and clean the
soiled surfaces with the cleaner and a fleece cloth.
5. For safety, you can attach the antenna base additionally. Drill through the existing
holes in the respective antenna to the roof of your car and fix it with a screw and
locking nut. In order for the freshly bonded feet can not slip, wait with this work until
the adhesive has cured.
6. After the complete assembly and curing of the adhesive, a silicone fugue can be
drawn around the antenna bases.
06
ENGLISH
2. Installation

2.3 Indoor installation

1. The coaxial cable is laid in the interior of the vehicle.
2. Make sure when choosing a location for the control unit and the set-top box that both
devices are in a dry and protected place.
3. Do not place the control unit and the set-top box in a location near heat sources and
ensure sufficient ventilation.
4. Here are the basic connections for the antenna system:
• Connect the power supply (red and black cable) for the controller with your battery
of the vehicle via a fuse (7 amps) to avoid a cable fire at short circuit. The yellow ca-
ble is connected to the ignition plus of the vehicle, and also protected by a fuse of 7
amps (This cable must only be connected if the antenna is to automatically retract
when the engine starts). The remaining black cable is connected to the negative
pole of the associated ignition system (mass).
• Connect the cable coming from the antenna to the control unit:
- 10 m coax cable with f-connector to „ANTENNA"
• Connect the control unit to the set-top box:
- 1 m coax cable with f-connector from „RECEIVER" to set-top box
Note:
If you have the Caravanman Kompakt Twin, connect a second coaxial cable
from the antenna directly to the second set-top box.
ENGLISH
07