Assembly Of The Stem - SQlab 8OX Serie Mode D'emploi

Potence
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

Assembly of the stem

Warning
Badly assembled components are a significant hazard.
• You must read and understand the instructions and notes
in the manual before you begin assembly.
• If you have any questions about installing these compo-
nents, contact your SQlab dealer or have the stem assem-
bled by an experienced mechanic at your SQlab dealer.
The scope of delivery of the 8OX stem comprises a stem, 6 screws (4 x M6x18, 2 x M6x16) and two clamps for fixing the handlebars in the
stem (Fig.1). An Ahead cap is not included. The scope of delivery of the 8OX Trial Fabio Wibmer consists of a stem, 6 screws (6x M4x18)
and a clamp to fix the handlebar in the stem. An Ahead cap is not included in the delivery.
(Fig.1)
Carefully read the handlebars and fork user information before assembly. If there are any questions, doubts or contradictory require-
ments, ask your SQlab dealer for advice before assembly.
The SQlab 8OX stem is designed to be mounted on 1 1/8 inch steerer tubes with a clampable length of at least 32 mm and handlebars
with a diameter of 31.8 mm in the clamping area (Fig.2; Fig. 3). When using headset spacers, make sure that the steerer tube protrudes
32mm (8OX Trial Fabio Wibmer 38mm) so that the stem can be clamped properly (Fig.3). The clamping area of the handlebars must be at
least 50 mm wide (8OX Fabio Wibmer 40 mm.
1 1/8"
Ø 28,6 mm
(Fig.2)
M6x16
Ø 31,8 mm
Caution
To fit an eMTB, eBike and pedelec, certain country-specific
standards, rules and regulations must be followed.
• In Germany, please observe the "Guideline for Conversion
to Pedelecs" of the Zweirad-Industrie-Verband eV (bicycle
industry association) (http://www.ziv-zweirad.de/) in co-
operation with Verbund Service und Fahrrad geV (www.vsf
.de) and Zedler – Institute for Bicycle Technology and Safe-
ty GmbH (www.zedler.de).
• SQlab 8OX stems are NOT generally approved for fast
pedelecs (S-pedelec up to 45 km/h).
Clamps
(Fig.3)
M6x18

Publicité

Table des Matières
loading

Table des Matières