FloTech Programmable CheckMate Retain / Overfill Monitor
noble tin-plated stranded copper wire which resists corrosion.
When installed properly, this cable will provide years of reliable
service. See the Proper Wire Connections section for more
detailed directions about stripping and terminating the cables.
Monitor Housing
After the monitor housing is mounted, install FloTech FT402 cable
glands in the openings where needed. These are, as illustrated in
Fig.3: Power, Top Sensors, Bottom Sensors (if equipped) and
Socket. Route the lengths of FloTech FT404 cable through the
conduit openings. Cut the cables to length leaving approximately
8 inches of extra length inside the monitor housing.
Unused conduit openings in the sensor housings must have a ½
inch NPT pipe plug installed. Note that when using the FloTech
FT390 Dual Socket Assembly, you only need to install one cable
gland for the socket wiring.
Fig. 3
Monitor Housing Cable Routing Diagram
FT208 CheckMate
REV G
Page 7