Operation; Normal Operation - FloTech FT208 Mode D'emploi

FloTech Programmable CheckMate Retain / Overfill Monitor
8. Once the LED pattern representing the number of
connected sensors is correct, move SW1 to "RUN"
position. The monitor will flash the sensor LEDs
sequentially through the test pattern. At this point, if all
connected sensors are dry and the AUX LED is on, the
PERMIT LED should light and no RED LEDs are lit.
9. Remove power from the trailer or turn power off to the
monitor. Remove the programming module, reconnect the
timer reset switch, and turn power back on to the monitor.

Operation

Normal Operation

When power is applied to the FT208 monitor, the unit will
sequentially flash the sensor LEDs through the power up test
pattern. This sequence is from the TOP #1 LED to the TOP #8
LED then from the BOTT #1 LED to the BOTT #8 LED.
Once this sequence is completed, the unit tests all the sensor
inputs.
Page 16
PROGRAM MODULE POSITION
REV G
FIG. 11
FT208 CheckMate