Monitor Indicators; Monitor Connections - FloTech FT208 Mode D'emploi

FloTech Programmable CheckMate Retain / Overfill Monitor

Monitor Indicators

Refer to Fig. 1.
PWR LED
Yellow LED that indicates power is connected to the monitor.
PERMIT LED
Green LED indicates to the rack the sensors are permissive.
TOP LEDs
Overfill Sensor Indicators, ON indicates a wet sensor.
BOTTOM LEDs
Retain Sensor Indicators, ON indicates a wet sensor.
OPTIC FROM RACK (THERM A) LED
Red LED indicates no pulse from Optic Rack Monitor (YEL) or no
signal to Thermistor Rack Monitor (RED) A channel.
OPTIC TO RACK (THERM B) LED
Red indicated no signal to Optic Rack Monitor (ORG) or no signal
to Thermistor Rack Monitor (ORG) B channel.
AUX LED
Green LED indicates the Auxiliary input is permissive.

Monitor Connections

TB1 – 12/24 VDC Power Connections
TB2 – Aux Input and Timer Reset. Program Key Input.
TB3 – Overfill Sensor Inputs
TB4 – Retain Sensor Inputs
TB5 – Optic and Thermistor Socket Connections
TB6 – Non I.S. Output Relay
FT208 CheckMate REV G Page 5