Num'axes Canifugue Small Guide D'utilisation page 24

AUTOMATIC SYSTEM
Diagram 4 – Sample installation
As soon as the animal wearing a collar
enters the protected area, he is warned by
Antenna wire
beep sounds.
2 m between
If he continues to move forward, towards
both wires
the antenna wire, the collar emits stimu-
Warning
lations.
By twisting the outward strand with the inward
area
The antenna wire is placed on the ground,
strand, wave emission is blocked and the
buried or raised on an existing fence.
animal can move freely within this zone.
For the system to function, the wire must
Stimulation
form a continuous loop.
area
Both wires (inward and outward) must be
Transmitter
spaced 2 meters apart.
Twisted wire
• Activate/deactivate the transmitter
• Activate: connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter
and into a wall outlet. The green indicator light on the transmitter comes on, the transmitter is On.
• Deactivate: disconnect the AC adapter from the wall outlet. The green indicator light on the transmitter goes out, the
transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire
break alarm would alert you to a connexion default (ref. § Safety features – wire break alarm).
• Charge of the battery
WARNING: it is necessary to fully charge the battery of your collar before the first use.
To charge the battery of your collar, your collar must be turned off.
To charge your product, proceed in the following way:
− connect the charger to the charging station
− connect the charger to a wall outlet
− put the collar on the charging station (make sure to respect the orientation of the collar on the charging station – see
Diagram 5). After a few seconds, the indicator light on the collar starts blinking in green.
− when the battery is fully charged, the green indicator light switch Off
− remove the collar from the charging station
− disconnect the charger for the wall outlet
A full charge takes approximately 2 hours.
24