How The Pet Fencing System Works; Installing The Pet Fencing System - Num'axes Canifugue Small Guide D'utilisation

Masquer les pouces Voir aussi pour Canifugue Small:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Fig. 3
Nylon strap
Indicator light:
On/Off indicator
+
battery level indicator

How the pet fencing system works

You can define your pet's play area by installing a wire, called antenna wire, around the authorized perimeter. This wire placed
on the ground, buried or raised on an existing fence carries a radio signal from the transmitter.
When your pet, wearing a receiver collar, approaches this wire, he is warned by beep sounds that he is too close to an area
where he is not allowed; then if he carries on, static stimulations will be emitted by the collar. Your pet will have to leave the
unauthorized area to stop the stimulations and beep sounds.
An unlimited number of receiver collars can be used with one transmitter: you can keep as many cats and dogs as
you wish safely in the same area.
The CANIFUGUE SMALL pet fencing system has been designed to give you complete satisfaction with an antenna wire with a
maximum length of 400 meters (equivalent to one square hectare). If a longer antenna wire is used, the pet fencing system
will still work, but the warning and stimulation zones will be markedly reduced.

Installing the pet fencing system

• Transmitter
The transmitter must be installed indoors in a dry location: the transmitter can withstand changes in temperature but will be
damaged by water. Make sure the transmitter is correctly and surely fixed (for example, screw it to a wall).
Install the transmitter in a garage or garden shed near an electrical outlet (220 V AC).
• Antenna wire
For the system to operate, the wire must be connected to the transmitter and form a continuous loop from the transmitter and
back again. The outward and inward wires must be spaced 2 meters apart to avoid cancelling the signal.
0.52 mm² or 1.5 mm² wire can be used (you can combine several wire sections).
Contact points
(short or long)
22
symbol:
area where the switch magnet
is located
This magnet allows you
to switch On/Off the collar
and to select the level of
stimulation
Magnetic key
(magnet)

Publicité

Table des Matières
loading

Table des Matières