Mounting - Lenze EMB9351-E Instructions De Mise En Service

6 Mechanical installation
Mounting in cold−plate design

Mounting

6.4.4 Mounting
Before screwing the cooler and the cooling plate of the braking unit together,
apply the heat conducting paste supplied, in order to keep the heat transfer
resistance as low as possible.
Clean the contact surface using spirit.
ƒ
Apply the heat conducting paste in a thin layer using a spattle or a paint
ƒ
brush.
–
The heat conducting paste in the accessory kit is sufficient to cover a
surface of approx. 1000 cm
Mount controller to the heatsink with 4 M5 fixing screws.
ƒ
–
Screw−tightening torque: 3.4 Nm (30 Ib−in).
l
Fig. 9 Dimensions
Type
9351−V003
9352−V003
94
g
c
a
a b
[mm] [mm]
52 381
2
.
b1 c
[mm] [mm]
350 34
l
e
9350br_004
d e g
[mm] [mm] [mm]
367 104 6.5
EDBMB935X DE/EN/FR 12.0