Kinetec Prima Advance Mode D'emploi page 26

Masquer les pouces Voir aussi pour Prima Advance:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
14 • WARRANTY
The KINETEC warranty is strictly limited to the replacement free of charge or repair in the plant of the component or
components found to be defective.
KINETEC guarantees its joint passive mobilization systems for 2 years against all defects of manufacture from the date of
purchase by the consumer.
KINETEC is the only organization able to assess the application of the warranty to its systems.
The warranty will be considered null and void if the device has been used abnormally or under conditions of use other
than those indicated in the user's manual.
The warranty will also be considered null and void in the event of deterioration or an accident due to negligence,
inappropriate surveillance or inappropriate maintenance, or due to transformation of the equipment or an attempt to
repair the equipment.
15 • OPTIONS
15.1 • 4665003297 • Trolley
15.2 • 4655001053 • Cart
15.3 • 4650001090 • Mattress
15.4 • 4650001868 • Patient pad Kit (4 straps + foot support + 1 mattress)
15.5 • 4650001123 • Leg strap
15.6 • 4670023701 • Plastic support kit
GUIDANCE AND MANUFACTURER'S DECLARATION
The « KINETEC Prima Advance » is intended for use in the electromagnetic environment specified below. The customer or the user of the « KINETEC
Emissions test
Radio electric-Frequency emissions
CISPR 11
Radio electric-Frequency emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations / Flicker emissions
IEC 61000-3-3
The « KINETEC PRIMA Advance » is intended for use in the electromagnetic environment specified below. The customer or the user of the « KINETEC
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient /
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage interruptions
CEI 61000-4-11
Voltage dips and voltage
variations on power supply
input lines
CEI 61000-4-11
Power frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE : U
is the a.c. mains voltage prior to application of the test level.
T
Prima Advance
Electromagnetic emissions
Prima Advance » should assure that it is used in such an environment.
Electromagnetic immunity
PRIMA Advance » should assure that it is used in such an environment.
Immunity test
±2 kV, ±4 kV, ±6 kV
contact
±2 kV, ±4 kV, ±8 kV
air
±2 kV for power supply
±2 kV for power supply lines
lines
±1 kV between lines
±2 kV between line and
earth
< 5% U
T
(>95% dip in U
)
T
for 5 seconds
< 5% U
T
(>95% dip in U
)
T
for 0,5 cycle
40% U
T
(60% dip in U
)
T
for 5 cycles
70% U
T
(30% dip in U
)
T
for 25 cycles
3A/m
Emissions test
The « KINETEC Prima Advance » uses RF energy only for its internal
Group 1
function. Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
Class B
The « KINETEC Prima Advance » is suitable for use in all establishments
including domestic establishments and those directly connected to
Class A
the public low-voltage power supply network that supplies buildings
used for domestic purposes.
Complies
Immunity test
Floors should be wood, concrete or ceramic tile. If floors
are covered with synthetic material, the relative humidity
±2 kV, ±4 kV, ±6 kV
should be at least 30%.
contact
If the movement stops, push the start button, the
movement starts again.
±2 kV, ±4 kV, ±8 kV
If the yellow LED is lighting, switch off then on the
air
apparatus and push the start button, the movement starts
again.
Mains power quality should be that of a typical
commercial or hospital environment.
±1 kV between lines
Mains power quality should be that of a typical
±2 kV between line and
commercial or hospital environment.
earth
< 5% U
At the interruption, there is a reset of the « KINETEC PRIMA
T
(>95% dip in U
)
Advance ». After turning on, push START to begin the
T
for 5 seconds
session.
< 5% U
T
(>95% dip in U
)
T
for 0,5 cycle
Mains power quality should be that of a typical
commercial or hospital environment. If the user of the
40% U
T
« KINETEC PRIMA Advance » requires continued operation
(60% dip in U
)
T
during power supply interruptions, it is recommended that
for 5 cycles
the « KINETEC PRIMA Advance » be powered from an
uninterruptible power supply or a battery.
70% U
T
(30% dip in U
)
T
for 25 cycles
Power frequency magnetic fields should be at levels
3A/m
characteristic of a typical location in a typical commercial
or hospital environment.
GB
Emissions test
Immunity test
4/4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Prima advance s1

Table des Matières