Kinetec Prima Advance Mode D'emploi page 24

4 • STARTING THE UNIT
Turn on the power switch (2). The yellow light (3) on the control panel is on.
START / STOP / REVERSE function
The KINETEC Prima Advance is fitted with a START/STOP/REVERSE function.
First, press the hand control switch; the machine stops.
Press the hand control switch again; the mobilization reverses.
IMPORTANT: for maximum safety, the hand control should always be given
to the patient.
Adjusting the FLEXION and EXTENSION limits
Select the extension and flexion angles via button (4) for flexion and
button (5) for extension.
Modification of the extension or flexion limit can be done while the
machine is running or stationary.
Adjusting the SPEED
The SPEED is set by turning button (6).
At maximum speed, the machine moves at 145° per minute (for medium femur length).
At minimum speed, the machine moves at 40° per minute (for medium femur length).
Modification of the speed can be done while the machine is running or stationary.
5 • USE OF THE KINETEC PATIENT PAD KIT
The KINETEC Patient Pad Kit is designed for rapid fitting, optimal hygiene and maximum patient comfort.
For optimal hygiene, a new set of pads should be used for each patient.
- For using and positioning the straps, please refer to here under.
CLEANING:
Disinfecting of the pads: Washing at 30°C with use of a
disinfecting solution during the rising cycle.
Example of product that can be used: Solution "
Baclinge" at 0.125 % or "Souplanios" at 0,125% from
ANIOS Laboratory.
Part number to order the complete set:
- Set of 4 straps: 4650001107
- Foot support: 4650001131
6 • SETTING UP THE PATIENT
- Place the KINETEC Prima Advance machine in a
position that will be comfortable for the patient.
- Measure in cm or inches the length of the patient's
femur; adjust the thigh support to this measurement
using knobs (7).
- To install the patient on the KINETEC Prima Advance
machine.
- Push the foot plate (C) up to the patient and
tighten the knobs (8).
IMPORTANT
Adjust the axis of the patient's hip with the axis
rotation of the KINETEC Prima Advance machine,
and the axis of the patient's knee with the axis
rotation of the KINETEC Prima Advance machine.
7 • POSITIONING THE FOOT PLATE
The articulated foot plate allows the positioning of the foot from 40° of PLANTAR
FLEXION to 30° of DORSIFLEXION.
- The knob (9) allows positioning the foot in plantar flexion or dorsiflexion.
Prima Advance
C
GB
3
6
8
7
9
4
5
2/4