Focal DSA 500 RT Manuel D'utilisation page 9

PERFORMANCE EXPERT DSA 500 RT
U s e r m a n u a l
9
3.4. Connection of the input signals on the DSA 500 RT
The connection phase for the input/output cables can begin.
3.4.1. Your car radio is equipped with RCA outputs
Connect the RCAs to the amplifier (fig.5. ), complying with the polarities (INPUT Left = black or white; INPUT Right
1
= red). Connect the other ends of the RCAs to the RCA outputs of the car radio.
Then connect the REMOTE cable to the amplifier (REM terminal) by screwing it down firmly. Connect the other end
of the REMOTE cable to the car radio REMOTE terminal (fig.5. )
2
Finally, connect the speaker cables to the amplifier while complying with the polarities (+ on +; - on -) using the
adjusted crimps (fig.5. ).
3
Fig.5
1
3
2
Beware
!
The speakers or speaker kits cables on the DSA 500 RT must have an impedance of more than 2 ohms.
Using lower impedances voids the warranty.