Software Compatibility - Focal DSA 500 RT Manuel D'utilisation

PERFORMANCE EXPERT DSA 500 RT
U s e r m a n u a l
6. Troubleshooting
!
The status of the various LEDs reflects certain defective modes or causes of failures.
Check all the possible causes below. If normal operation cannot be restored despite these checks, contact the DSA
500 RT installer or distributor.
Subwoofer LED status Remote control LED
status
On Off
Rapid blinking Rapid blinking
Rapid blinking Rapid blinking
Rapid blinking Rapid blinking
Rapid blinking Rapid blinking
Off Off
Off Off
Off Off
Off Off
Off Off
On On

7. Software compatibility

PC
MAC
Terms and conditions of the warranty
If you encounter problems, first contact your Focal distributor. The warranty for France on all Focal materials is for
two years. In the event of faulty equipment, it should be sent, at your own expense, in its original packaging to your
distributor, who will then analyse the equipment and determine the nature of the problem. If it is under warranty, the
equipment will be returned to you or replaced "postage paid". Otherwise, a quote for repair will be sent to you. The
warranty does not cover damage arising from improper use or incorrect connection.
Outside France, Focal equipment is covered by a warranty but the terms and conditions are set locally by the official
Focal distributor in each country in accordance with local legislation.
Sound present Possible origin
YES Remote control connection
defect
YES/NO Or noisy Output short circuit
No Internal voltage defect.
No Amplifier overheating
No Power supply voltage
too low.
No No power supply.
No No REM signal in RCA
connection mode.
No No REM signal in HIGH
LEVEL connection mode
No Fuse failure.
YES/NO Or noisy Grounding problem
YES/NO Or noisy Grounding problem
• Windows Xp/Vista/Seven/8
• Mac OS X since version 10.6
Action to take
Switch off the stereo system.
Check the remote control cable and the connection in "9".
Switch off the stereo system.
Check the speakers, their connections and the speaker
cables.
Switch off the stereo system.
Remove the fuse for the +12 V power supply cable for 10
seconds, then reconnect.
Switch off the stereo system. Wait until it cools down.
Check that 12 V is always present between terminals "3"
and "4".
Switch off the stereo system.
Check that 12 V is always present between terminals "3" and "4".
Switch on the stereo system.
Check that 12 V is always present between terminals "4" and "5".
Switch on the stereo system.
Switch off the stereo system.
Check the fuses and replace them if necessary.
Switch off the stereo system.
Check that terminal "4" continues to be connected to the
vehicle chassis.
Switch off the stereo system.
Check that terminal "4" continues to be connected to the
vehicle chassis.
15