Focal DSA 500 RT Manuel D'utilisation page 13

PERFORMANCE EXPERT DSA 500 RT
U s e r m a n u a l
13
3.7. Start-up and checks
Fig.10
The connection phase is now complete. You must still verify the correct power supply
as well as the correct operation of the complete system (car radio/DSA 500 RT/
loudspeakers). Set all gains for the source to their minimum. Set the DSA 500 RT gain
to 1/3 (fig.10). Turn on the different elements. Once all elements are on, carry out a test
at low volume.
4. Real-time connection
The DSA 500 RT is now operational. The audio system can now be configured
using the software graphics interface.
Before any USB is connected, install the FOCAL MANAGER RT software
(available on the FOCAL website).
The procedure includes installing the specific pilot for managing and configuring
Fig. 11
the USB connection properly.
For all problems relating to software installation, look at the notice on software available on line (FOCAL website).
Once the software is installed, launch the application.
Connect the USB using the real-time control connecter at the back of the remote control unit.
A message is displayed on the screen, offering several options for the import of the DSP configuration; the connection
is then established and tuning can then begin.
5. Control panels and connections
Amplifier:
Fig. 12
7 7 3 4 5 6 6 6 6 9 2 10 1 1 11 11