Focal DSA 500 RT Manuel D'utilisation page 10

PERFORMANCE EXPERT DSA 500 RT
U s e r m a n u a l
10
3.4.2. Your car radio is only equipped with amplified outputs (speaker outputs)
If the car radio does not have RCA outputs, a high-level input is available on the DSA 500 RT.
This adapter makes it possible to connect using the car radio speaker outputs instead of the RCA outputs.
Connect the high-level adapter to amplifier (fig.6. ) while complying with the polarities (INPUT Left +/INPUT Left -,
1
INPUT Right +/INPUT Right -) given in figure 7. Connect the other ends of the RCAs to the RCA* outputs of the car
radio.
It is therefore not essential to wire the REM input, the DSA 500 RT being equipped with a signal detection system on
the high-level inputs.
Finally, connect the speaker cables to the amplifier while complying with the polarities (+ on +; - on -) using the
adjusted crimps (fig.6. )
2
Beware
!
The speakers or speaker kits cables on the DSA 500 RT must have an impedance of more than 2 ohms.
Using lower impedances voids the warranty.
Fig. 6
2
1
2