GYS GYSCAP 680 E Manuel D'utilisation page 13

Operating manual
Start the vehicle as quickly as possible before the capacity is transferred to the battery.
Wait for the GYSCAP to charge until the digital display shows
(once charged, the GYSCAP is ready to be used again.
After switching off the GYSCAP with the button:
Disconnect the GYSCAP clamps from the vehicle.
Wind up the cables and put them in the dedicated space.
If the vehicle does not start after two attempts, the problem is probably not battery related.
Locate the source of the problem prior to any other starting attempt.
Failure at the first attempt will discharge the GYSCAP.
i
Before any new attempts, charge the GYSCAP.
Check the section «charging the GYSCAP»
In the event of a particular breakdown: The vehicle battery is in deep discharge (< 1 V).
Connect the GYSCAP clamps to the battery, ensure that the polarity is correct.
The booster is no longer protected in this mode. In order not to damage the vehicle and
the GYSCAP, avoid reversing the polarity at all costs.
Press the Power button.
The digital display shows the GYSCAP voltage capacity.
Battery status display: voltage at the end of the clamps.
Press the button for 3 seconds to perform a forced start.
A 45 seconds countdown starts.
Start the vehicle as quickly as possible before the capacity is transferred to the battery.
Wait for the GYSCAP to charge until the digital display shows
(once charged, the GYSCAP is ready to be used again.
After switching off the GYSCAP with the button:
Disconnect the GYSCAP clamps from the vehicle.
Wind up the cables and put them in the dedicated space.
Translation of the original
instructions
.
.
GYSCAP
13