Waste Management - GYS GYSCAP 680 E Manuel D'utilisation

Operating manual
Connection:
• Class III device.
Maintenance:
• - Maintenance should only be carried out by a qualified person.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations:
• Equipment complies with European directives
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
• Material complies with British requirements.
The UK Declaration of Conformity is available on our website
(see cover page).
• Device consistent with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website.

Waste management::

• This product should be disposed of in an appropriate recycling
facility. Do not dispose of in domestic waste.
• This product should be recycled appropriately
GENERAL DESCRIPTION
Designed for vehicles equipped with a 12 V (GYSCAP 680E) or 24 V (2x 12 V, GYSCAP 24V) batter y, this autono-
mous starter
is equipped with supercapacitors. It uses the battery voltage of a running vehicle to recharge itself and within seconds
it will start the engine of a broken down vehicle.
GYSCAP CHARGE STATUS
Press the Power button.
The internal capacity status of the GYSCAP is displayed.
The digital display shows a single bar: The capacity of GYSCAP is insufficient.
Refer to the paragraph "Rec harging the GYSCAP" .
The digital display shows four bars: The GYSCAP is not fully charged, but it is possible to start a
vehicle.
It is still recommended to charge it fully, see the «charging the
GYSCAP ».
10
Translation of the original
instructions
GYSCAP