Sample Connections For The Use Of Multiple Cameras With Dc Power Supply; Settings; Dip Switch Settings - Eneo VK-1315S Mode D'emploi

3.1 Sample connections for the use of multiple cameras with DC-power supply
VIDEO OUT jack
VIDEO OUT jack
PHASE
Note
PHASE adjustment

4. Settings

4.1 DIP switch settings

EIN
AUS
Label ON / DC
E/I
For lenses with fixed or manual iris setting
Automatic shutter
mode (AES)
A/I
For DC voltage controlled lenses
Auto Iris
AGC Constant video signal level at low light or
Automatic changing light conditions
Gain Control
Power supply
Power supply
Read the operation manual first.
Power up unit and other components only after all connections are made.
Continuously turn potentiometer P of camera 1 until the picture off sampling pulse is
synchronous to that of camera 2. Should this be impossible, the same adjustment must
be made to camera 2, yet in the opposite direction to that of camera 1. Subsequently
align camera 3 with camera 2, camera 4 with camera 3 etc., in accordance with the
above-described method.
VIDEO IN jack
VIDEO IN jack
VIDEO IN jack
OFF / VID
Shutter must be set to off for DC voltage
or videosignal controlled lenses.
For videosignal controlled AI lenses
AGC off
15
Switch over unit
VIDEO OUT jack
Monitor