Installation Instructions; Power Supply Connections - Eneo IPC-52A0003M0A Guide D'installation Rapide

Installation instructions

CAUTION: The mounting bracket should be attached to a struc-
tural object, such as concrete, hard wood, wall stud or ceiling
rafter that supports the weight of the camera. If necessary use
appropriate mounting material (e.g. anchors) instead of the
material enclosed with the mounting bracket.
Mount the camera to the wall or ceilling with a corresponding mounting bracket through
the camera mount holes (1/4" thread insert) on its top or bottom.
CAUTION: Extreme care should be taken NOT to scratch the
window in front of lens.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.

Power supply connections

Make sure the power is removed before the installation. Camera can work with either
24VAC or 12VDC, dual voltage power and PoE (IEEE Std. 802.3af ). It does NOT require
the polarity-matched connection for 12VDC supply. Primary and secondary grounds are
completely isolated to avoid the possible ground loop problems.
After all connections are finished properly, follow the order for applying power.
1. Plug the network cable into RJ-45 Ethernet Port. If PoE is the unique power, there
will be no need to connect Power terminal.
2. When DC12V or AC24V Local power is necessary, connect the low voltage (DC12V
or AC24V) first, then plug the AC adapter to AC outlets to avoid an improper reset
from power jitter and a damage from the surge voltage when no load.
i When PoE and local dual power are connected at the same time, local power has
priority.
EN
7