Installation Instructions; Pan & Tilt Adjustments - Eneo MEB-62F0036P0A Mode D'emploi

Installation instructions

CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Route the Power cable to the connecting place.
3. Place the camera bracket on pre-drilled position and fix it through using mount-
ing screws.
4. Set the camera's viewing angle by using the driver. (Refer to 'TIP' ).
5. Put the sunshield to the camera unit and tighten the sunshield-bolt.
Pan & Tilt adjustments
• Unlock the Lock/Unlock screw on the camera bracket using the driver.
• Adjust the camera's viewing angle then lock the Lock/Unlock screw and fix the sub-
lock screw on the other side of bracket.
Mounting Screw (3.5x25 mm) Plastic Anchor (6 x 30 mm)
EN
7